Contra Angle Air Motor Straight Low Speed Dental Handpiece Set

Message

Enter the code in the box below:

$??.00

Have chosen: There are no options selected.

*Hole
Order After Login

Added To Cart Successfully!

Contra Angle Air Motor Straight Low Speed Dental Handpiece Set
Contra Angle Air Motor Straight Low Speed Dental Handpiece Set
Contra Angle Air Motor Straight Low Speed Dental Handpiece Set
Contra Angle Air Motor Straight Low Speed Dental Handpiece Set
Contra Angle Air Motor Straight Low Speed Dental Handpiece Set
Contra Angle Air Motor Straight Low Speed Dental Handpiece Set
Contra Angle Air Motor Straight Low Speed Dental Handpiece Set
Contra Angle Air Motor Straight Low Speed Dental Handpiece Set
Contra Angle Air Motor Straight Low Speed Dental Handpiece Set

Contra Angle Air Motor Straight Low Speed Dental Handpiece Set

     
PriceShow price after login

Available Options

Hole*

If you have your own design, please contact us, there will have a professional customer service to communicate with you.

Don't have your files right now?No worries, Check out our art tips for more information.

If over 500pcs, mass production will start until pre-production sample has been approved.

Est. 7 days production

Contra Angle Handpiece
Low Speed 22,000-27,000 rpm.
The shank of the instrument mounted therein is 2.35 mm
Fastening of the instruments with a turning latch
Autoclavable 135°C
For any lab or E-type motors


Straight Handpiece
Working pressure: 0.3MPa (4-hole); 0.25MPa (2-hole) (Measure meter is installed at the end of air motor to measure the air pressure).
Revolution: about 22000-27000r/min (adjustable between clockwise or anticlockwise)
Noise: ≤68dB
Air consumption: about 56L/min
Ratio: 1:1
Max speed: 25000rpm/min.


Air Motor
Supply air pressure: 245-392KPa (2.5-4kgf/CM2)
1:1 Direct Drive
Max speed 20000rpm/min

Write a review

Write a review

Note: HTML is not translated!
   Bad      Good

{{up_most_image}}

No need register, just fill in contact info below, we will reply you within 24 hours!

Enter the code in the box below: